Get M4B Flexispot

Flexispot Standing Desk Evaluation …M4B Flexispot…

Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are very little, here are a few features that I wasn’t necessarily a huge fan of:

The bundle that the desk came in was heavy, so bringing it inside was a group effort, but this is simply a consequence of how durable the Flexispot is.
The hassle-free cable television tray was a little bit complicated to set up. In the end, you eventually slip it under screws, which wasn’t extremely clear from the instructions.
You will require to purchase an anti-fatigue mat to remain comfortable, however this is a good idea for any standing desks, so I can’t fault Flexispot for that.

When it got here and I saw how heavy it was, I was both thrilled (because this meant it was going to be sturdy) and also a little reluctant (since we all know just how much of an obstacle assembling furniture can be).

Fortunately, with the help of an educational YouTube link, it took me only around 42 minutes to put together. Scratch that, it took my 11-year-old child, with some supervision from me, from start to finish. The only problem I have with assembly was the cable tray, which I discovered wasn’t explained well in the instructions.

When put together, I like the streamlined appearance of this desk. I’m confident any of the many diverse finishes that it comes in would look terrific in any office, and the adjustable width makes it simple to fit it in even the tiniest of home offices.

The peaceful operation and height memory settings make it simple, efficient, and peaceful to switch in between sitting and standing as often times as you desire throughout the day.

Finally, this desk is sturdy. It can hold up to 335 lbs even while in operation, so if you have a significant desktop (or want to rest on it for some reason) it has you covered. It will also uniformly distribute weight no matter how unbalanced the weight you place on it is, it won’t wobble or wiggle.

 

in that video is pretty kitted out as the desk we’re looking at today is quite basic I attempted to get as close to that as I could on uplifts site with equivalent configurations the flexi spot desk we’re taking a look at today will run you about four hundred and 10 dollars versus six hundred and fifty for a comparable desk from uplift I try to get as close as possible with the uplift design is in fact five inches longer but you can do a lot with five inches boom yes now for transparency flexi area did send this desk out for review however as you should know by now doesn’t impact my evaluation in any way the desktop here is 55 inches large 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not delivering up until completion of April at the earliest the desktop is an inch thick however it’s this fundamental laminate as you can potentially get lacking even any cable grommets for travel through the outdoors carton

for the desktop was not damaged in any way which is entirely strange because I might shoot a 30-second b-roll montage of just the damage and flaws on this desktop scuffed scraped pitted just very rough guy if I had acquired this I ‘d have been on the phone with customer support right away they did also managed to miss drilling the pilot holes where you can attach the control box to the desktop a lot of having to do that myself without mistakenly drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface area to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was actually pretty straightforward the entire thing came together in about 45 minutes and despite the fact that there’s cable televisions running to it from each element to support motorized function strangely definitely where any sort of cable television management products whatsoever the frame on this system is a single motor double stage style versus the dual motor three-stage design that comes standard with the uplift desk this can be updated too to both the double phase dual motor and a three-stage double motor which pushes the expense of the desk up

an extra 70 dollars the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per second the height can vary from just under 28 inches to simply over forty seven point six inches so a max I ‘d it is more than tall adequate even for me and I remain at 6 foot for this design does come basic with the control board that enables up-and-down movement plus three memory areas with an LED readout to tell you the desk height the single motor style utilizes this drive shaft assembly which needs to be changed as the width of the desk is adjusted the motor operation itself while it might be slow is extremely peaceful as in barely audible this outside a cost would be the one benefit I would offer this system over the uplift desk and I wish to beware here since this isn’t a hit piece this desk is 240 dollars cheaper than the similar uplift design over 35% cheaper even if you upgrade this flexi spot test to the dual motor three-stage design it still comes in a hundred and seventy dollars less expensive than the uplift however more affordable does not mean cheap this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is strong even if max height I’ll absolutely give it that however the lateral stability of this desk the horizontal motion at this cost point it’s unacceptable it’s add fuel to the fire here they include a little security baffle this little steel piece that installs to the frame and covers a part of this turning driveshaft when

this desk sees any lateral movement at all the drive shaft hits this baffle and the sound is definitely infuriating to leading things off I decided to add rolling casters to this desk this was a $30 upgrade and 2 of those 4 casters arrived damaged too my plan for this desk at this moment is to lose the desk top and featured entirely and change it with a white laminate lemon table from Ikea and use it as an adjustable picture table which you can’t do this frame will accommodate desktops up to 63 inches wide and 31 and a half inches deep so this will roll around the studio make it much easier to movie products without needing to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift initially that is a financial investment in quality office furniture that will last you this at best feels like a less expensive replica of that it simply does not feel quality and the difference between this desk and my primary desk is night and day do feel free to have a look at their website also which also feels strangely comparable to one of their competitors there’s a wealth of accessories you can get for the flexi spot desk as much as and including a foot massager and even a stationary exercise bike and I could invest another 10 minutes of our precious time covering numerous alternatives and accessories I might however I think I’m happier that they only sent out a basic desk since as a fundamental desk I’m not a fan of the quality assurance at this cost point and I don’t think slapping on a bunch of additionals is the relocation when the core product isn’t what it need to be they do provide a 30-day trial if you’re simply morbidly curious and they service warranty their desks for 3 years very desk is 5 years and uplift desk is 7 years if you are M4B Flexispot

in the market for a sit-stand desk they’re fantastic mine’s been a life changer for me both in terms of gaming and efficiency but I would invest the additional money it’s gon na take to enter a greater end producer like uplift desk or extremely desk and I haven’t personally utilized extremely desk products so I can’t speak on it but their credibility is very good big thanks to flexi area for sending this out for review unfortunately I can not recommend this unit and for the record I’m a hundred percent sure they would have happily replaced the parts that I had a problem with seeing as how both the desktop and the casters got here harmed however from a customer viewpoint you ‘d probably be really excited to get this in